Raspberry Pi Add-On Board 2021 Updated Version PoE+ HAT Power over Ethernet HAT for Raspberry Pi 4B and 3 Model B+

I've got six of these now, 5 on Pi 4s and 1 on a CM4.
They can be a little loud, but if you set the config up right in /boot/config.txt, you can get them a little quieter.
Jeff Geerling has a good blog post on doing this.
The first few batches I got had a known issue where the fan screws are too long and hit the Camera connector, but the latest batch I got from PBTech had this issue resolived. I've got six of these now, 5 on Pi 4s and 1 on a CM4.
They can be a little loud, but if you set the config up right in /boot/config.txt, you can get them a little quieter.
Jeff Geerling has a good blog post on doing this.
The first few batches I got had a known issue where the fan screws are too long and hit the Camera connector, but the latest batch I got from PBTech had this issue resolived.

Works well but I tweaked the speed at which the fan kicks into high speed as it is quite noisy. Works well but I tweaked the speed at which the fan kicks into high speed as it is quite noisy.

By: PeterC87 29/08/21

Verified Owner

I recently used Power over Ethernet (PoE) to supply a Raspberry Pi 4 with 8GB running the 64-bit Pi OS Bookworm, all within a solar-powered setup that boasts a low carbon footprint. I’m pleased to report that the product performed exactly as expected!

This plug-and-play solution is perfect for anyone needing PoE capabilities. However, I did encounter a minor challenge while fitting the aluminum case. The board's crystal interfered with aligning all the GPIO pins, but I was able to resolve this by gently bending the screw latch. Once adjusted, everything fit perfectly.

This slight difficulty is the only reason I’m marking it down, but it cou...view more I recently used Power over Ethernet (PoE) to supply a Raspberry Pi 4 with 8GB running the 64-bit Pi OS Bookworm, all within a solar-powered setup that boasts a low carbon footprint. I’m pleased to report that the product performed exactly as expected!

This plug-and-play solution is perfect for anyone needing PoE capabilities. However, I did encounter a minor challenge while fitting the aluminum case. The board's crystal interfered with aligning all the GPIO pins, but I was able to resolve this by gently bending the screw latch. Once adjusted, everything fit perfectly.

This slight difficulty is the only reason I’m marking it down, but it could also be attributed to the case design. Overall, I'm satisfied with the experience and would recommend it to others in similar setups.

Easy to install and works great with Unifi PoE switch, but fans are a tad too loud out of the box. Recommend getting fan config from Jeff Geerling’s website. Easy to install and works great with Unifi PoE switch, but fans are a tad too loud out of the box. Recommend getting fan config from Jeff Geerling’s website.

The PoE HAT does exactly what it's supposed to do. The only problem is, with the HAT on, my Raspberry Pi 3B+ no longer fits in its case. Finding a decent replacement that can fit a HAT seems almost impossible. Maybe a USB PoE splitter may have been a better choice for me. The PoE HAT does exactly what it's supposed to do. The only problem is, with the HAT on, my Raspberry Pi 3B+ no longer fits in its case. Finding a decent replacement that can fit a HAT seems almost impossible. Maybe a USB PoE splitter may have been a better choice for me.

I had to reseat this product and the soldering is so cheap/badly done that the pins pulled right off the board. Rendering it immediately unusable. I had to reseat this product and the soldering is so cheap/badly done that the pins pulled right off the board. Rendering it immediately unusable.