Lian Li PCI-E Riser Card + PCI-E Slot Back Panel for O11 Series, allows you to vertically mount your GPU features a PCI Express 16x Gen3 interface and a 220mm cable length.

Works great. Pays to note, you can't use bottom fans with the full bracket installed.

However, with a bit of kiwi ingenuity, you could potentially use this without the bottom bracket, and have bottom fans installed in PC-011 Dynamic... of course this isn't recommended by the manufacturer. Personally I ended up with the full bracket installed, as it is extremely sturdy and secure! Works great. Pays to note, you can't use bottom fans with the full bracket installed.

However, with a bit of kiwi ingenuity, you could potentially use this without the bottom bracket, and have bottom fans installed in PC-011 Dynamic... of course this isn't recommended by the manufacturer. Personally I ended up with the full bracket installed, as it is extremely sturdy and secure!

it is a bit expensive but if you are willing to take the plunge it makes your graphics card look great

Pros:
Great for gpu display
easy install

Cons
very expensive it is a bit expensive but if you are willing to take the plunge it makes your graphics card look great

Pros:
Great for gpu display
easy install

Cons
very expensive

My GPU was too tall to fit in the O11 Dynamic (170mm tall) but this fixed that issue very well
The manual could have been a little more clear about what holes to use. but still easy to install

Does block 2 of the 3 lower fan slots. but could always mount thin 120mm fans externally to get around this My GPU was too tall to fit in the O11 Dynamic (170mm tall) but this fixed that issue very well
The manual could have been a little more clear about what holes to use. but still easy to install

Does block 2 of the 3 lower fan slots. but could always mount thin 120mm fans externally to get around this

I had to shave down one side of the connector shroud because it didn't fit the supplied bracket properly. Fortunately it was only like 0.5mm and made of rubber so was very easy to do, but still, this shouldn't have been required. It's not as secure as a case mounted card, difficult to get screws into where they need to go, and the instructions were lacking clarity

But

It does what it's meant to do and the final result looks great. I had to shave down one side of the connector shroud because it didn't fit the supplied bracket properly. Fortunately it was only like 0.5mm and made of rubber so was very easy to do, but still, this shouldn't have been required. It's not as secure as a case mounted card, difficult to get screws into where they need to go, and the instructions were lacking clarity

But

It does what it's meant to do and the final result looks great.

I would have designed the bracket differently, and had white options, but does the job and I can paint it. I would have designed the bracket differently, and had white options, but does the job and I can paint it.

works great works great