Pros:
- Easy to swing and lower / raise my 28" monitor
- Visually appealing
Cons:
- When mounted to the desk and fully extended, the arms are too short to raise the monitor to the recommended eye level (for good posture, I'm 6ft).
- VESA mount is not detachable so the monitor must be held up in place while attaching to the arm which is difficult. Pros:
- Easy to swing and lower / raise my 28" monitor
- Visually appealing
Cons:
- When mounted to the desk and fully extended, the arms are too short to raise the monitor to the recommended eye level (for good posture, I'm 6ft).
- VESA mount is not detachable so the monitor must be held up in place while attaching to the arm which is difficult.

easy to set-up: the clamp mount can be pulled right apart so that you can work with a desk cramped up against a wall.

range of movement: great for monitors with a low vesa mount. One of my monitors has the vesa mount in its top half, which renders some of the arm movement useless :( My other monitor has the vesa mount holes on the bottom half and so I can move it all over the place however I want.

trick for newbies: you might think it's hard to get the arms to move if you try moving them without the monitors mounted, but once you have the monitors on it the arms move real smooth and position well. At first I was worried the arms w...view more easy to set-up: the clamp mount can be pulled right apart so that you can work with a desk cramped up against a wall.

range of movement: great for monitors with a low vesa mount. One of my monitors has the vesa mount in its top half, which renders some of the arm movement useless :( My other monitor has the vesa mount holes on the bottom half and so I can move it all over the place however I want.

trick for newbies: you might think it's hard to get the arms to move if you try moving them without the monitors mounted, but once you have the monitors on it the arms move real smooth and position well. At first I was worried the arms weren't moving at all, but once I got my monitors on it was all good. Clever gas I guess.

I'm happy with my choice, I'd recommend it.

I went into buying this arm with no desk mounting experience and found it easy to set up, just make sure the depth of you desk (above and below where you are mounting) exceeds 12cm just to be safe.
Quality for price is top notch, arms are sturdy holding my 2 27" LG Ultragear monitors and maneuvering is easy.
Once you have the arms where you want them they can be tightened to fix them in place with a covered bolt on the joint of the arm, its accessible at any position too.
All round a great purchase, I'm very happy with it I went into buying this arm with no desk mounting experience and found it easy to set up, just make sure the depth of you desk (above and below where you are mounting) exceeds 12cm just to be safe.
Quality for price is top notch, arms are sturdy holding my 2 27" LG Ultragear monitors and maneuvering is easy.
Once you have the arms where you want them they can be tightened to fix them in place with a covered bolt on the joint of the arm, its accessible at any position too.
All round a great purchase, I'm very happy with it

Got these around 29Dec 2021 and they've been working wonders imo nice white and black mix which I like with my setup being white, cables you can hide which is pretty cool for cable management.

I've seen couple people complain about it not being able to extend enough and I honestly don't see a problem as I'm 6 foot and monitors are perfect for me.

Only con I really came across was that I was sort of confused on how to build the thing as I didn't bother reading instructions because looked too confusing Got these around 29Dec 2021 and they've been working wonders imo nice white and black mix which I like with my setup being white, cables you can hide which is pretty cool for cable management.

I've seen couple people complain about it not being able to extend enough and I honestly don't see a problem as I'm 6 foot and monitors are perfect for me.

Only con I really came across was that I was sort of confused on how to build the thing as I didn't bother reading instructions because looked too confusing

By: TheunsS 13/01/22

Absolutely disappointed with quality control of this product. The screw holes where the clamp attaches to the mount has not been died out so there is no possible way you can screw in the screws. Cannot attach any sort of clamp without tapping the holes out yourself. CHECK THE SCREWS FIT IN THE HOLES BEFORE YOU TAKE THIS PRODUCT AWAY. Absolutely disappointed with quality control of this product. The screw holes where the clamp attaches to the mount has not been died out so there is no possible way you can screw in the screws. Cannot attach any sort of clamp without tapping the holes out yourself. CHECK THE SCREWS FIT IN THE HOLES BEFORE YOU TAKE THIS PRODUCT AWAY.

Product is fairly easy to setup,
Using it to support 2 x AOC 24inch wide monitors and handles the weight easily
Cable management works well, only visible at the elbow but its not mad at all.
cant compare this to the normal spring operated as I have never owned one before, but this gas spring seems to works well
Would definitely recommend Product is fairly easy to setup,
Using it to support 2 x AOC 24inch wide monitors and handles the weight easily
Cable management works well, only visible at the elbow but its not mad at all.
cant compare this to the normal spring operated as I have never owned one before, but this gas spring seems to works well
Would definitely recommend

By far the worst designed monitor mount, below were the problems:

- Base Screws were cross threaded (this ended with the monitor mount not sitting straight)
- Arms are in a fixed position with no room for flexibility, there's only one way to have the monitors mounted
- VESA plate was not sitting properly (was too loose and cannot tighten) so the monitor would be tilted on an angle
- Base damaged my desk even though there's a small amount of foam padding used (not enough)
- Design is very flimsy and instructions are not at all clear By far the worst designed monitor mount, below were the problems:

- Base Screws were cross threaded (this ended with the monitor mount not sitting straight)
- Arms are in a fixed position with no room for flexibility, there's only one way to have the monitors mounted
- VESA plate was not sitting properly (was too loose and cannot tighten) so the monitor would be tilted on an angle
- Base damaged my desk even though there's a small amount of foam padding used (not enough)
- Design is very flimsy and instructions are not at all clear

I've dealt with a lot of different monitor mounts in my time as a IT technician, and I can confidently say this is a great dual-monitor mount, easy to attach to desk, nice and sturdy feeling, easy to adjust monitor positioning and the ability to easily tidy power and display cables into the arms is much appreciated!
Only downside is that the VESA mounts cannot be removed and slotted in/out, which makes attaching the monitors a bit of a pain - would recommend doing this on a table (covered with a towel or something to protect the monitors) or the floor as you wrangle them into place. But once you've got them in, works like a dream. I've dealt with a lot of different monitor mounts in my time as a IT technician, and I can confidently say this is a great dual-monitor mount, easy to attach to desk, nice and sturdy feeling, easy to adjust monitor positioning and the ability to easily tidy power and display cables into the arms is much appreciated!
Only downside is that the VESA mounts cannot be removed and slotted in/out, which makes attaching the monitors a bit of a pain - would recommend doing this on a table (covered with a towel or something to protect the monitors) or the floor as you wrangle them into place. But once you've got them in, works like a dream.

it's definitely strong and sturdy and well built.
I popped in 2x 27" monitors - only reason for 3 stars is when you put monitors of this size, the length of the arms don't allow for a high amount of versatility in arranging them. Should be fine for 23-24" monitors. it's definitely strong and sturdy and well built.
I popped in 2x 27" monitors - only reason for 3 stars is when you put monitors of this size, the length of the arms don't allow for a high amount of versatility in arranging them. Should be fine for 23-24" monitors.

I bought the $80 version initially and it failed within 3 months, swapped for this one, even though double the price but seems much better. Arms still holding up find hopefully will keep lasting. I bought the $80 version initially and it failed within 3 months, swapped for this one, even though double the price but seems much better. Arms still holding up find hopefully will keep lasting.

Works great looks great and the price is bang on.
Purchased online, got a TXT 20mins later to come
pick it up, it was the last 1 in stock (at that time)
which means the stock count was correct - these
simple things make me happy.
Is the Christchurch Central store the best in NZ?
Yes because the systems obviously work and the
staff are awesome. Works great looks great and the price is bang on.
Purchased online, got a TXT 20mins later to come
pick it up, it was the last 1 in stock (at that time)
which means the stock count was correct - these
simple things make me happy.
Is the Christchurch Central store the best in NZ?
Yes because the systems obviously work and the
staff are awesome.

Good monitor stand.
The arms don't quite have the same level of fine-tuned height control as in other stands I've seen, but, it honestly hasn't been a problem for me so far, and likely wont be for most people. Good monitor stand.
The arms don't quite have the same level of fine-tuned height control as in other stands I've seen, but, it honestly hasn't been a problem for me so far, and likely wont be for most people.